Premium MECOFLOCK D561 Adhesive & MECODUR H5580 Hardener for flocking applications.

MECOFLOCK D561 flocking adhesive is a specially formulated two-component water based adhesive, designed for use on a wide range of PVC, soft-PVC and leather type materials. MECOFLOCK D561 is suitable for use with the following application methods; spraying, rolling and with a squeegee.

MECOFLOCK D561 when cross-linked with the MECODUR H5580, show very good resistances to water and UV light. We recommend the addition of 5% MECODUR H5580 when drying/curing with heat. MECOFLOCK D561 can be dried at 50°C for 20 to 30 minutes, however 24 hours (single component) or 72 hours (two-component) should be given to allow a full cure. MECOFLOCK D561 may also be dried at room temperatures above 20°C. The final cure of the adhesive at room temperature is normally reached after 72 hours. 

MECOFLOCK D561Adhesive is most commonly used for flocking on to PVC and leather materials.

If you are interested in buying in bulk, please contact us for pricing.

There are various ways to apply this adhesive and the following methods can be used (although some will be more successful after the viscosity of the adhesive has been reduced):

•    Paint Roller
•    Spray Gun
•    Squeegee
 
The adhesive must not be applied to any part of the substrate that does not require flocking. Those areas should be covered with a mask or sealed off with masking tape.

Adhesive should cover at least 10% of flock fibre length.
The adhesive must be viscose enough to support the flock fibres during the cure.